Change mac address mikrotik router

How to Mac and IP Address filter using Mikrotik Router (100% Workable)-mikrotik-routeros

By clicking "Post Your Answer", you acknowledge that you have read our updated terms of service , privacy policy and cookie policy , and that your continued use of the website is subject to these policies. Home Questions Tags Users Unanswered.

how to change mac in port - MikroTik

None of these solutions work for me: Omid Estaji. Omid Estaji Omid Estaji 3 1 1 5. Please make sure your packages are Clamped like this: Put these rules on top on the mangle table. Arash Arash 8.


  • Post navigation?
  • cyrillic fonts for mac free.
  • How to restore the standard mac-addresses of MikroTik interfaces.

This mss issue might be on PPTP server as well, so check the server mss config too. OMG Thank you so much!

Post navigation

Please make make it as answered if it works! I can't make three of them and errors appear "Couldn't add New Mangle Rule - tcp mss clamping not possible in prerouting and input chains.

Your Answer

If this is the case, here is how you can reset it to default. Have you checked it from another remote connection?

Knowledge Base

I don't think so. I checked every rules. A bit late joining the party here, but I had a similar problem.


  • change hard drive icon mac!
  • MikroTik Commands – Tikdis.
  • keygen generator mac photoshop cs6.

When you change the computer that you have connected to your cable modem service, you usually have to call up Tech Support and give them the MAC address of the NIC in the new machine. Since hardware routers have the equivalent of a NIC on their WAN port in order to connect to your cable modem, you would have to do the same thing if you're installing a router.

How to Lock MAC and IP Address in Mikrotik

Recently, however, some ISPs have started to recognize the MAC addresses of popular routers and disconnect service if a router is detected. Fortunately, many router manufacturers are including the capability to either set the router WAN port MAC address to anything you want, or copy it from a computer connected to the router LAN side.

You can check the Router comparison chart under "Mac addr. Then consult the router's documentation for directions on using the feature. If you use the feature, make sure you copy the MAC address from the computer that was used when your cable modem service was installed. After you set the new address, you'll probably need to power down your router, power cycle your cable modem, then power up your router in order to properly connect to your ISP.


  • Solved: Re: EPMP Elevate - Duplicate MAC Addresses - Cambium Networks Community;
  • Leave a comment;
  • how to change Mac Address - MikroTik.
  • flatbed scanners for mac mountain lion.
  • ipod to itunes transfer free mac.

Advertiser Disclosure: Some of the products that appear on this site are from companies from which QuinStreet receives compensation. This compensation may impact how and where products appear on this site including, for example, the order in which they appear. QuinStreet does not include all companies or all types of products available in the marketplace. Acceptable Use Policy.